Electrolux DITOMIX 5 Instruction Manual page 23

Refer to the numbered drawings
that go with the numbered paragraphs in the instructions
Contents
Introduction
Installation
Use and Safety
Cleaning and Hygiene
Fault finding
Introduction
1. DESCRIPTION
1
• This beater mixer is a small semi-professional bakery and
pastry-making or kitchen appliance, designed for whisking and
mixing. It also provides good results for kneading. The power
take-off is used to power accessories such as a Ø50 mincer
and a vegetable slicer (or any accessory with a tapered press
fitting and 12mm square shaft). Being light and compact, it is
easy to use.
A
1.
1a
B
C
D
E
F
G
H
Installation
2. DIMENSIONS - WEIGHT (for information only)
1
- Gross weight when packaged: 13 kg
- Net weight when equipped: 11 kg
2. LOCATION
2
This beater mixer can be stood on a stable, non-resonating
work table of a height of between 600 and 900 mm.
2. ELECTRICAL CONNECTION
3
• The beater is to be supplied with single-phase current.
• An easily-accessible, waterproof, standardised 10-16A, 2
pin + earth wall socket is required.
• Check that the electric mains voltage, the value shown on
the specification plate and the label on the power cable are
the same.
The machine must be earthed using the green and
yellow wire
NO EARTH PLUG = NO PROTECTION = RISK OF FAILURE
Note: The earth values are defined according to the residual
differential current. (See standard NFC 15100 and PROMO-
TELEC guide). Non-compliance with these instructions may result
in invalidation of the warranty.
Stainless steel bowl, 5.5 litre capacity
Support
Safety guard
Integral accessories socket
Cover
Trim
On / Off / Speed selector button
Base
1 Maintenance
1 Compliance with regulations
2 Parts list - exploded view
3 Electrical diagrams
1.
1b
• Standard equipment: • Standard equipment: • Standard equipment:
• Standard equipment: • Standard equipment:
A Kneading hook.
B Paddle for mixing.
C Whisk for emulsions
D Scraper spatula
2.
1
- Packaging dimensions: 450 x 350 x 490 mm
- Machine overall dimensions: 284 x 434 x 382 mm
• The machine must be protected by a residual current devi-
ce (RCD) and a 16 A fuse.
• Machine electrical specifications:
Supply Rating
(V) (W)
220/240 500
100/120 500W
1
Frequency Current
(Hz) (A)
50/60 2,3
50/60 4.6
Ditomix 5 GB 07 05
GB
12/2005
4
5
A
E