Step 8. Attach Apt - MacDon R80 Unloading And Assembly Instructions

STEP 8. ATTACH APT

CAUTION
Keep hands clear when lowering APT.
a. Remove the six bolts and nuts from frame and
retain for reinstallation.
b. Using a forklift or equivalent, manoeuvre APT
into position and install pivot pin (A) into
mower-conditioner frame.
NOTE
Use the jack to adjust the pitch of the
APT for proper alignment when installing
pivot pin.
NOTE
Pin may need to be tapped into final
position with a hammer due to the tight
clearances.
Form # 169080
UNLOADING AND ASSEMBLY
c. Secure pivot pin (A) to frame by installing six 5/8 x
d. Torque to 250 ft-lbf (339 N·m).
e. Install bolt (B), lockwasher, and flatwasher
f.
A
g. Check oil level in site glass (D) on the left side of
h. If necessary add single grade trans-hydraulic oil at
16
A
B
1.75 long Gr. 8 bolts (C) with lock nuts removed at
step a. Install bolts with heads facing aft.
removed at STEP 7g. at lower end of pivot pin
and tighten bolt.
Position APT with jack so that rear span of APT is
approximately horizontal.
from APT.
E
the APT, is between ADD and FULL.
filler pipe (E).
RECOMMENDED OILS
Petro-Canada Duratran
Case IH Hy-Tran Plus®
New Holland Hydraul
Shell Donax TD
C
Remove lifting chain
D
Chevron 1000 THF
Agco Power Fluid 821XL
Esso/Exxon Hydraul 56
John Deere Quatro® J20C
Model Year - 2010