Step 6. Remove Forming Shield - MacDon R80 Unloading And Assembly Instructions

STEP 6. REMOVE FORMING
SHIELD
a. Position lift forks with extensions under forming
shield at front of header.
b. Cut shipping wire and remove four bolts at
front edge of forming shield.
c. Cut shipping wire (2 places) on aft end of
forming shield at rear of header.
d. Manually slide forming shield onto lift forks.
Form # 169080
UNLOADING AND ASSEMBLY
e. Remove five bolts and nuts on each door and
f.
g. Cut plastic ties at end curtains and remove
h. Ensure that curtains hang properly and completely
13
remove front angles and lift hooks. Retain lower
side bolt (A) for re-installation at same location
after hook is removed.
WARNING
Ensure cutterbar is completely clear of foreign
objects. These objects can be ejected with
considerable force when the machine is
started and may result in serious injury or
machine damage.
Thoroughly check cutterbar area for wooden
blocking, banding, and hardware that may have
fallen between discs.
creases in curtains.
enclose cutterbar area. Minor creases in curtains
will eventually straighten out.
A
Model Year - 2010