Step 15. Attach Mower Conditioner To Tractor; Drawbar Type Hitch - MacDon R80 Unloading And Assembly Instructions

STEP 15. ATTACH MOWER
CONDITIONER TO
TRACTOR
CAUTION
Shut off tractor, engage parking brake and
remove key before working around hitch.
A. DRAWBAR TYPE HITCH
I. SETUP THE DRAWBAR
Adjust tractor drawbar to meet ASAE Standard
specifications as listed below.
DIMENSION
1.37" DIA.
X 16 in. (406 mm)
6-12 in. (152-305 mm)
Y
8 in. (203 mm) Recommended
13-17 in. (330-432 mm)
Z
16 in. (406 mm) Recommended
X
Y
Z
Form # 169080
UNLOADING AND ASSEMBLY
1000 RPM PTO
1.75" DIA.
20 in. (508 mm)
PTO
TRACTOR
DRAWBAR
GROUND
II. ATTACH DRAWBAR EXTENSION
a. Secure the drawbar so the hitch-pin hole is
directly below the driveline.
b. Unpack hitch parts bundle.
c. Attach the drawbar extension (A) to the tractor
drawbar as follows and as shown:
B
1. Loosen bolts (B) on extension assembly and
slide onto drawbar. Install pin (C).
2. Tighten the four bolts to 265 ft-lbf (359 N·m).
CAUTION
Never attach mower-conditioner to tractor rear
axle or three-point hitch arms.
E
d. Attach the swivel hitch member (D) with pin (E)
onto the mower-conditioner APT.
21
A
C
D
(continued next page)
Model Year - 2010