Step 2. Unload Header - MacDon R80 Unloading And Assembly Instructions

STEP 2. UNLOAD HEADER

CAUTION
To avoid injury to bystanders from being
struck by machinery, do not allow persons
to stand in unloading area.
CAUTION
Equipment used for unloading must meet
or exceed the requirements specified
below. Using inadequate equipment may
result in chain breakage, vehicle tipping or
machine damage.
LIFTING VEHICLE
Min. Lifting Capacity
Min. Lifting Height
Overhead Lifting Quality
(1/2 inch)
WARNING
Be sure forks are secure before moving
away from load. Stand clear when lifting.
a. Remove hauler's tie down straps and chains.
FORKS
b. Approach mower-conditioner from either its
"underside" or "topside" and slide forks in
underneath lifting
possible.
Form # 169080
UNLOADING AND ASSEMBLY
8000 lb. (3630 kg)
15 ft. (4.5 m)
CHAIN
5000 lb. (2270 kg)
Min. Working Load
framework as far
When
underside
scratching the unit.
c. Raise mower-conditioner off deck.
Take care not to contact the other machine
if load is two-wide.
d. Back up until unit clears trailer and slowly lower to
6 inches (150 mm) from ground.
e. Take to storage or set-up area set machine down
securely on level ground.
f. Repeat for other mower conditioner if required.
g. Check for shipping damage and missing parts.
as
9
NOTE
possible, approach
to minimize potential
IMPORTANT
Model Year - 2010
from the
for