Step 11. Install Hydraulic Motor - MacDon R80 Unloading And Assembly Instructions

STEP 11. INSTALL HYDRAULIC
MOTOR
a. Remove shipping wire that holds motor to
steering cylinder.
A
b. Remove four bolts (A) securing plate (B) to
gearbox and remove plate. Retain bolts.
c. Position motor on gearbox as shown and re-
install the four bolts (A). Torque to 103 ft-lbf
(140 N·m).
Form # 169080
UNLOADING AND ASSEMBLY
B
A
18
d. Route hoses through hose guides.
If required, loosen the hose swivel fittings at
the motor ports to remove any twist in the
hose routing from the APT. Do not loosen
the clamp type fitting.
e. On 16 ft headers, remove bracket (B) and secure
hoses and wiring harness to header with bracket
(B). Adjust hoses as required.
NOTE
B
Model Year - 2010