Table of Contents
Advertisement
TeeJet Tank Rinsing Nozzle
A TeeJet tank rinse nozzle can be installed for
rinsing the inside of the tank. The nozzle rotates
o
360
and is driven by fluid from the spray system.
The coverage by the rinse nozzle is 6 ½ ft (2 m).
The rinse will output 20 USgpm (77 LPM) at 50 psi
(345 kPa) and has a maximum operating pressure
of 300 psi (2000 kPa). It is made of corrosion-
resistant Teflon.
To operate the rinse nozzle:
1. Add clean water to the tank.
2. Start the engine. Engage the sprayer pump
and increase the engine throttle to half.
3. Open the rinse nozzle valve (D). The rinse
nozzle valve for the front tank is located above
the agitation valve (C).
valve to maximum for complete flushing of the
solution tank.
D
C
B
A
Plumbing System with Rinse Nozzle and
Valve installed.
OPTIONS AND ATTACHMENTS
Open the agitation
85
When the sprayer is equipped with a rear tank, the
rinse nozzle in the rear tank is operated by
opening the agitation valve (C) on the plumbing
system. While the spray pump is circulating clean
water, open the rinse nozzle valve (E) located at
the top of the rear tank.
Rear Tank Rinse Nozzle and Valve
E
Advertisement
Table of Contents
