Clean Water Personal Wash And Emergency Rinse Tank - MacDon 625 Operator's Manual

Clean Water Personal Wash and Emergency Rinse Tank

There is a square, yellow tank located on the left
boom near the plumbing tree.
hose that will gravity feed or an auxiliary tap that
can be used in the case of emergency and to
protect against pesticide contamination.
Fill the tank with clean water every day and check
regularly to ensure there is adequate water in the
event of an emergency and for the day's use.
Remove the fill cap on top to fill the tank with
water.
To operate the gravity feed hose on the rinse tank:
1. Pull down on the hose until it breaks free from
the upper fitting.
2. Water will begin flowing from the opening in
the hose when the hose is below the water
level in the tank. Hold the hose and opening
below the tank to ensure the water is allowed
to drain completely from the tank.
covering the opening and/or squeezing the
hose which would reduce the flow of water
from the tank.
3. Position the contaminated area of the body
under the opening of the hose and flush the
affliction with running water from the hose.
To operate the tap:
1. Turn the valve on the tap until water begins to
flow from the tank.
2. Position the contaminated area of the body
under the opening of the tap and flush the
affliction with running water from the tap.
There is storage compartment molded in the tank
that can be used to store detergent, soap and
shampoo, face cloth, and towels. To access the
compartment, pull down on the metal locking latch
and lift the black lid to the upright position. After
using stored items close the lid and return the
metal latch to lock it shut.
CHEMICAL SAFETY
The tank has a
Avoid
14
Hose
Tap
Emergency Rinse Tank Gravity Feed Hose and
Manual Tap
Fill Cap
Storage
Emergency Rinse Tank