Table of Contents
Advertisement
Bottom Filling the Tank
The bottom fill feature is part of the spray system
plumbing located in the left pod of the sprayer
attachment.
To fill the tank using the bottom tank fill system,
turn the valves of the plumbing tree to the bottom
filling position and use the following procedure:
NOTE: Refer to page 84 for instructions on
bottom filling the sprayer when it is equipped with
a rear tank.
1. Place the run/hold switch on the MT-3405 rate
controller to the "HOLD" position and the boom
selector switches to the "OFF" position.
2. Open the bypass valve B.
3. Locate the quick disconnect opening. Remove
dust cap from the opening and attach the
supply line from the nurse tank to the quick
disconnect opening.
4. Turn on the spray system pump.
main line valve A so that the direction arrows
on the valve handle point towards the nurse
tank, away from the sprayer, and the sprayer
pump.
5. When the required amount of water has been
added to the tank, return the main line valve A
so that the direction arrows point towards the
main tank and the sprayer pump.
sprayer pump.
6. Close the bypass valve B.
7. Disconnect the supply hose and replace the
dust cap.
OPERATION
Dust Cap and
Turn the
Shut off
31
C
B
A
Opening
Plumbing System
Advertisement
Table of Contents
