Table of Contents
Advertisement
TRANSPORTING THE WINDROWER: FLATBED
CAUTION:
procedure
windrower on a flatbed trailer.
1. Raise header with tractor hydraulics and install
lift cylinder stops.
2. Position lean bar to hang vertically downward.
Install only one bolt per side. (Remove divider
rods, if equipped.)
3. Remove complete rear forming shield group, in
whole.
4. At tongue pivot, back off two 5/8 nuts (B)
approximately 3/4 inch (20 mm). This clears the
stop to allow pivoting the tongue past the
normal travel range.
NOTE: If tongue does not raise up as nuts (B)
are loosened, lift rear of tongue with forklift to
clear stops.
5. Detach rod end of tongue shift cylinder from
frame and swing tongue to the right until no
part of tongue extends forward of header R/H
end panel (that is, the tongue must not widen
the shipping package). Secure the cylinder to
the tongue for shipping. Tie tongue to frame at
float arm (C) to prevent movement. (Use
cardboard or suitable material under the tie to
protect paint.)
CAUTION: Be sure forklifts are large
enough to lift the windrower safely.
See Specifications section for weight
of the unit.
6. Position two forklifts as shown, lift windrower
and back the flatbed trailer under the unit.
IMPORTANT: To allow windrower to rest
securely on header panels, hitch end of tongue
must
extend
over
approximately 2 feet (0.6 m).
7. Lower windrower onto flatbed so its weight
rests on the tires and sloped edge (D) of
header end panels.
8. Block wheels and tie the unit down securely.
Form # 147008
OPERATION
Use
the
following
when
shipping
the
rear
of
flatbed
by
C
LOOSEN NUTS TO RAISE TONGUE
NOTE: TONGUE DOES NOT WIDEN SHIPPING
PACKAGE AND HITCH END OF TONGUE
EXTENDS APPROX. 2 FT. OVER END OF FLATBED
RAISE UNIT - POSITION FLATBED
LOWER AND TIE DOWN UNIT
38
B
C
D
Issue 12/05
Advertisement
Table of Contents
