Table of Contents
Advertisement
TRANSPORTING THE WINDROWER
CAUTION: Use correct transport
procedure as detailed here:
1. Be sure all lock pins are properly installed in
transport position. See "Converting From Field
Position to Transport" in this section.
2. To ensure adequate braking performance and
control, tow only with a vehicle weighing at
least 5000 lbs. (2300 kg).
3. Be sure hitch chain is properly attached to
towing vehicle. Provide only enough slack in
chain to permit turning. See "Attaching
Windrower to Tractor" in this section.
4. To avoid loss of control in turns, be sure there
is at least 4 inches (100 mm) clearance (A)
from hitch pin to rear of towing vehicle.
5. Disengage PTO before transporting. Be sure
driveline is properly attached to tractor PTO.
See "Attaching Windrower to Tractor" in this
section. If transporting with a truck, the front
driveline half must be removed and stored, or
otherwise adequately secured.
6. Check local laws for width regulations and
lighting or marking requirements before
transporting on roads.
7. Keep Slow Moving Vehicle emblem, reflectors
and lights clean and visible.
8. Do not allow riders on tractor or windrower.
9. Travel speed should be such that complete
control and machine stability are maintained at
all times. Do not exceed 20 mph (30 km/h).
Reduce speed for corners and slippery
conditions.
Form # 147021
OPERATION
ENSURE CLEARANCE FOR TURNS
30
Issue 05/05
Advertisement
Table of Contents
