Safety Signs - MacDon 5020 Operator's Manual

SAFETY

SAFETY SIGNS

• The safety signs reproduced below appear on the windrower at the locations shown on page 7.
• Keep safety signs clean and legible at all times
• Replace safety signs that are missing or become illegible.
• If original parts on which a safety sign was installed are replaced, be sure the repair part also bears the
current safety sign.
• Safety signs are available from your Dealer Parts Department.
To install safety signs:
1. Be sure the installation area is clean and dry.
2. Decide on the exact location before you remove the decal backing paper.
3. Remove the smaller portion of the split backing paper.
4. Place the sign in position and slowly peel back the remaining paper, smoothing the sign as it is applied.
5. Small air pockets can be smoothed out or pricked with a pin.
A - # 44611
B - # 32738
C - # 32009
D - # 28403
G - # 115100
F - # 44944
E - # 140311
J - # 32008
H - # 140290
Form # 147008 Issue 12/05
6