Header Flotation - MacDon A30-S Unloading And Assembly Instructions

D. HEADER FLOTATION
The windrower float springs are not used to level
the header.
To adjust float, proceed as follows:
a. Check float by grasping the lean bar and lifting.
The force to lift
(335–380 N), and should be approximately the
same at both ends.
b. If necessary, perform the following steps to
adjust the float:
1. Raise header fully, shut down engine, and
remove key.
A
2. Turn drawbolt (A) clockwise to increase float
(makes header lighter), or counterclockwise
to decrease float (makes header heavier).
3. Re-check the float.
169078
PRE-DELIVERY CHECKS
should be 75–85 lbf
47
Revision E