Step 8. Adjust Lean Bar; Step 9. Adjust Pan Extensions: Grass Seed Special; Step 10. Adjust Lights - MacDon A30-S Unloading And Assembly Instructions

STEP 8. ADJUST LEAN BAR

a. Lean bar is fully retracted for shipping. Remove
hardware on both sides, and install lean bar in
field position at position suitable for crop
(normally 2/3 of the crop height).
b. Proceed to STEP 10. ADJUST LIGHTS. If this
is a Grass Seed Header, proceed as follows:
STEP 9. ADJUST PAN
EXTENSIONS: GRASS
SEED SPECIAL
The grass seed header auger pan extensions
are factory-installed for the widest delivery
opening. Adjust as follows:
A
a. Remove two bolts (A), and loosen bolt (B).
169078
UNLOADING AND ASSEMBLY
WIDE
C
B
b. Slide pan extensions (C) and swath forming rods
inboard to desired position, and align holes.
c. Re-install two bolts (A). Tighten bolts (A) and
(B).
d. Repeat for opposite pan extension.

STEP 10. ADJUST LIGHTS

a. Position amber light supports perpendicular to
header.
b. Check that pivot bolt is tight enough to hold light
support in upright position, yet still allow light to
pivot out of the way of obstructions.
Do not over-tighten mounting hardware.
c. Ensure base of light housings and bolted
connections on light supports provide proper
electrical grounding.
d. Amber reflector (D) should face direction of
travel. If required, remove bolts (E), flip reflector
assembly, and re-install bolts.
14
NARROW
C
A
B
D
E
NOTE
Revision E