Auger Stripper Bar Clearance; Reel Tine To Header Pan Clearance - MacDon A30-S Unloading And Assembly Instructions

B. AUGER STRIPPER BAR
CLEARANCE
a. Check for signs of auger flighting rubbing
stripper bars after run-up.
1/32–5/32 in.
(1–4 mm)
CLEARANCE
1/32–5/32 in.
(1–4 mm)
CLEARANCE
b. Check clearance between auger flighting and
stripper bars.
The auger should clear the stripper bars
on the auger pan by approximately
1/32–5/32 in. (1–4 mm).
stripper bars may be required.
169078
PRE-DELIVERY CHECKS
1/32–5/32 in.
(1–4 mm)
CLEARANCE
NOTE
Shimming the
C. REEL TINE TO HEADER PAN
CLEARANCE
0.08–0.39 in.
(2–10 mm)
The above dimensions are provided as
guidelines only.
contact the guards but not the knife
sections or the auger pan.
a. Rotate reel slowly by hand, and check tine
clearance at knife and pan.
simulate crop-loaded position to ensure tine
clearances to knife sections and auger pan are
AUGER
adequate for working conditions.
b. Check that reel rotates freely.
If there are a few reel tine that are
touching the pan while the rest are at the
correct height, trim the longer tines to
match the rest. Be sure to adjust both
sides of the reel. Ensure that tines do not
contact plastic header pan.
46
FLEX TINE BACK
0.08 in.
(2 mm)
IMPORTANT
Tines may slightly
Flex tines to
NOTE
Revision E