Step 14. Modify Hydraulics - MacDon A30-S Unloading And Assembly Instructions

STEP 14. MODIFY HYDRAULICS

A. A30-S
The M100, M105, M150 and M155 are factory-
configured with A30-S header hydraulics and
electrical harness.
CONFIGURE REVERSER VALVE JUMPER
HOSE.
M200 hydraulics need to be reconfigured to run
an A Series header.
through your Dealer), includes the additional
hose, hardware, and installation instructions.
Install the kits in accordance with instructions
that were supplied with the kits. Then, proceed
to STEP 15. CONFIGURE REVERSER VALVE
JUMPER HOSE.
M205 hydraulics need to be modified to accept
an A Series header, and kits B5491, B5492, and
B5497 should have been supplied with your
header. Install the kits in accordance with
instructions that were supplied with the kits.
Then, proceed to
HYDRAULICS.
B. A40-D
I. M100, M105
a. Open LH maintenance platform, and modify
valve block as follows:
1. At valve (D), remove the cap (E) from port
'R1' fitting, and the plug (F) from 'DWA' tee
fitting. Ports may not be identified.
169078
UNLOADING AND ASSEMBLY
Proceed to STEP 15.
Kit B4651 (available
STEP 16. ATTACH
D
R1
DWA
E
F
H
2. Remove female coupler assemblies (G) and
(L) from auger return and reel pressure hose
bundle (H) from header.
O
LARGE COUPLER ASSEMBLY (L)
3. Remove and discard cap (M) and adapter
fitting (N) with O-ring, from the large coupler
(O).
23
L
G
N
M
(continued next page)
Revision E