Initiating (Power-Up) - Will Burt Night Scan Powerlite Operating Instructions Manual

NIGHT SCAN POWERLITE, POWERLITE XTREME, AND POWERLITE HDT
OPERATING INSTRUCTIONS
4. Raise the mast to 90° and turn on the lights by performing one of the following steps:
• Quickly press "Mast Up" twice (Auto-Up feature) to move mast to 90° and turn both banks of
lights on. To abort the Auto-Up feature, press any controller button.
• Press and hold "Mast Up" to raise the mast. Then press "Lights" to turn the lights on. The
RCP will become active when the mast is at 90°. Only the controller buttons that have a lit
LED are active.
5. If desired, raise the mast further by pressing "Mast Up".
6. Position the lights vertically by pressing "Tilt Down" and "Tilt Up".
7. Position the lights horizontally by pressing "Pan Right" and "Pan Left".
8. Use the "AUX" button to turn on the strobe/beacon light (if equipped).
9. If desired, lower the mast by pressing "Mast Down".
10. Stow the mast by performing one of the following steps:
• Quickly press "Mast Down" twice (Auto Stow® feature). It is recommended to use the Auto
Stow® feature to stow the mast. To abort Auto Stow®, press any controller button.
• Press and hold "Mast Down" until all LEDs on the controller turn off. Ensure that "Mast Down"
is released only after the controller LEDs turn off which means the mast is stowed.
6.4

Initiating (Power-Up)

Perform the following to power up the system:
1. If the "E-Stop" was activated during prior use, it must be reset by turning to enable the system
to power-up. Do not reset the "E-Stop" until the cause of the event is corrected. Turn the red
"E-Stop" button if needed.
2. Press "NFPA Start" to power-up the mast.
On initiation, the Base Board establishes communication with the other boards in the system. If
communication cannot be established, an error code is shown on the display and the
communication system is shut down. The HHRC must be connected prior to power-up to be
recognized by the controller.
PAGE 48 OF 98 TP-4723701-U
MAY 2021