Unpacking & Handling - Will Burt Night Scan Powerlite Operating Instructions Manual

NIGHT SCAN POWERLITE, POWERLITE XTREME, AND POWERLITE HDT
5.3 Unpacking & Handling
Unpack and handle the items as follows:
1. Carefully remove all the small cartons from the large crate or carton.
2. Remove all the items from the small cartons.
3. Ensure all components are included and that the required tools are readily available. The
components in the system shipment are shown in Table 5-2.
Base Assembly
Bulkhead Control
Cable
Supply Air Hose
Wrench, HEX L-
Key 1.5 mm
Drawings of your
system to assist in
the installation
process
*The labels from the label kit can be applied where the operator deems appropriate in site of
the operating station.
**The 6 mm wrench is used to emergency stow the mast. If necessary, it can also be used in
conjunction with the 1.5 mm wrench to assist in disassembling the actuator. Contact The Will-
Burt Company's Service for detailed instructions on this process.
4. Inspect for any shipping damage. If damage has occurred, notify the carrier.
5. Unbolt (for wooden crates) and remove any banding fixing the mast to the shipping crate or
carton. Remove any banding fixing the mast.
TP-4723701-U
MAY 2021
Table 5-2 Components in the System Ship
RCP Assembly
Light Power Cable
Ferrite
Strobe Light
(Optional)
OPERATING INSTRUCTIONS
Lights
Board Power Cable
Label Kit*
Operator's Manual
Wired HHRC with
Bulkhead
Exhaust Hose
Wrench, HEX L-Key 6
mm**
D-TEC II (Optional)
PAGE 29 OF 98