Panel Mount Remote Control (Pmrc) - Will Burt Night Scan Powerlite Operating Instructions Manual

NIGHT SCAN POWERLITE, POWERLITE XTREME, AND POWERLITE HDT
The HHRC comes with a holder (see Figure 5-6) to hang the HHRC. Attach the HHRC holder at
a convenient location to hang the HHRC in a dry, protected environment. To install the holder:
1. Drill two holes 1.125 inches (28.6 mm) apart as appropriate for the screws and mounting
method (nut/bolt or sheet metal screw or other) selected.
2. The mounting screws are provided by the installer based on the method of attaching
selected. The recommended screw size is M4 flat head to sit flush with the surface after
installation. Use the proper installation torque for the screw selected and use thread locking
techniques to prevent the screws from backing out due to vibration. Mount the holder
ensuring the wedged side in the groove is facing upward to mate to the HHRC.
3. Place the HHRC on the holder.
Warning labels are shipped loose with the mast. These labels should be posted in view of the
operator.
5.6.2

Panel Mount Remote Control (PMRC)

If your system was not ordered with the optional PMRC, go to section 5.7.
The PMRC should be located where the operator has line-of-sight to the mast operating space.
The PMRC should be located in a protected, dry location (the PMRC is IP54). To attach the
PMRC:
1. Cut the panel according to the dimensions shown in Figure 5-7.
2. The screws are provided by the installer. #10 stainless steel screws are recommended with
an installation torque of 20-24 in.-lb. (2.2-2.7 Nm).
3. Place the PMRC through the panel cutout and secure with screws.
TP-4723701-U
MAY 2021
Figure 5-6 HHRC Holder
OPERATING INSTRUCTIONS
PAGE 35 OF 98