Panel Mount Remote Control (Pmrc) - Will Burt Night Scan Chief Series Operating Instructions Manual

NIGHT SCAN CHIEF
OPERATING INSTRUCTIONS
installation. Use the proper installation torque for the screw selected and use thread locking
techniques to prevent the screws from backing out due to vibration. Mount the holder ensur-
ing the wedged side in the groove is facing upward to mate to the HHRC.
3. Place the HHRC on the holder.
5.5.2

Panel Mount Remote Control (PMRC)

If your system was not ordered with the optional PMRC, go to section 5.6.
The PMRC should be located where the operator has line-of-sight to the mast operating space.
The PMRC should be located in a protected, dry location (the PMRC is IP54). To attach the
PMRC:
1. Cut the panel according to the dimensions shown in Figure 5-6.
2. The screws are provided by the installer. #10 stainless steel screws are recommended with
an installation torque of 20-24 inch-pounds (2.2-2.7 Newton-Meters).
3. Place the PMRC through the panel cutout and secure with screws.
PAGE 26 OF 80
Figure 5-5 HHRC Holder
TP-4602001-T
DECEMBER 2020