5.9 Attach canopy end caps
PH2
5.9.1 OPEN CANOPY PANE
5.9.2 FASTEN CANOPY END CAPS
• Unpack both canopy end caps
the box.
• Connect decorative lighting Ⓐ and slide the can-
D
opy end caps
onto the guides.
• Screw on front fastener of the canopy end cap
(M6x12 - PH2).
PH2
5.9.3 CLOSE THE CANOPY PANE
D
(left/right) from
D
Ⓐ
5.10 Fine adjustment of the
canopy drive
19
Attention
Adjust the canopy drive only at the lower
springs!
The fine adjustment is made at the fac-
tory for each tanning device.
The values determined are noted on the
device feet.
These are the values to be set!
If a readjustment is necessary over time, the canopy
drive must be adjusted by means of parallel adjust-
ment of the preload of the two springs, so that
the canopy stops independently in each position.
A s s e m b l y I n s t r u c t i o n s | 6700
PH2
α
α
α/
/6800
/7000
7900
α
37