• Follow the connection diagram on the
rear wall during installation!
4.7.2 REMOVE BED DAMPERS
• Lift the bed in the middle (second person) and
remove the top locking pin of the two dampers
(left/right).
3
• Close the bed, pull both dampers from the bottom
guide and take it out completely.
4.7.3 LOOSEN THE BED
• Slide the bed pane pilot pin ⑫ approximately 30cm
to the right.
⑫
• Push the two bed holding pins (left/right) with the
screwdriver to the inside and hold them with the
free hand to prevent them from falling.
PH2
A s s e m b l y I n s t r u c t i o n s | 6700
⑫
α
α
α/
α
/6800
/7000
7900
21