Install The Bed; Install Front Panel; Install Bed Pane - KBL 6700a Assembly Instructions & Menu Settings

5.6 Install the bed

PH2
5.6.1 REMOVE CANOPY PANE
• Lift out canopy panel (temporarily). Similar to dis-
assembling step (4.3.4).
5.6.2 INSTALL THE BED
• The installing of the bed is similar to the disassem-
bling steps (4.7).

5.7 Install front panel

PH2
5.7.1 INSTALL FRONT PANEL
• The installation of the front panel is similar to the
disassembling steps (4.5).
5.7.2 ADJUST THE BED LOCK
• Coarse adjustment of the bed lock. Details under
fine adjustment of the bed lock -> 5.14.
Remove all protective film!
5.7.3 INSTALL BOTTOM SEALS
5.7.4 CLOSE THE BED
36
A s s e m b l y I n s t r u c t i o n s | 6700
3
L
α α
/6800 /7000

5.8 Install bed pane

PH2
Remove protective film on the bottom!
• The film on the top stays on until after
aquaCool initialisation.
5.8.1 INSTALL BED PANE
• The installation of the bed pane is similar to the
disassembling steps (4.4).
5.8.2 INSTALL DUCTING PANE
• The installation of the ducting pane is similar to the
disassembling step (4.3.6).
Remove all protective film!
Center-align the ducting pane so that
the bed pane can move freely.
5.8.3 CLOSE THE BED PANE.
5.8.4 RE-INSTALL THE CANOPY PANE.
• Install the canopy pane > similar to disassembling
step 4.3.4.
• Connect interior control panel -> similar to disas-
sembling step 4.3.2.
• Clean inside of canopy pane.
α/ α
7900