KBL 6700a Assembly Instructions & Menu Settings page 34

5.4.4 INSTALL REAR PLASTIC CLADDING
Similar to disassembling step (4.8.4).
Remove all protective film!
5.4.5 FASTEN GUIDE PLATES
• The two guide plates are fastened outside to a box
with attachments.
LEFT
• Fasten the guide plates to the shoulder pieces (3x
4,2x9,5 - PH2 each).
LEFT
34
A s s e m b l y I n s t r u c t i o n s | 6700
RIGHT
RIGHT
PH2
α α
/6800 /7000
5.4.6 FASTEN EXHAUST AIR VENT
• Fasten exhaust air vent
A
5.4.7 PUSH THE DEVICE FLUSH WITH THE WALL
5.4.8 PRETENSION THE CANOPY
Similar to disassembling step (4.8.3).
• Set both springs to the factory default (see sticker
on device feets).
Components are under spring tension
Risk of injury by the canopy dropping
down.
• Support the canopy as long as it is
α/ α
7900
A
(4x M6 x 16 - PH2).
19
CAUTION
not fully tensioned.
PH2
PH2