Table of Contents
Advertisement
AT8402
To restart the board with the new startup configuration, the CLI command 'reload' is used:
(AT8402 Base Fabric) (Config)#reload
If the new startup configuration is considered functional after the reboot, it must be activated
permanently, or else the one that is still active will be used again:
(AT8402 Base Fabric) (Config)#startupslot 3 activate
4.5.3
Updating bootloader
The process of updating the bootloader is similar to updating the initrd. The main difference is
that only the secondary bootloader is updatable, the primary bootloader is HW protected.
To update the bootloader, the CLI command 'download' is used:
(AT8402 Base Fabric) #download bootloader tftp://192.168.50.5/bootloader.pkg
Updating the bootloader will disable management interfaces for a while.
Are you sure to update the bootloader? (y/n)y
Successfully transferred booloader image tftp://192.168.50.5/bootloader.pkg
...
(AT8402 Base Fabric) #
4.5.4
Updating IPMI
Updating the IPMI firmware is different from updating the other software parts as updating is
done directly when invoking the download command. In case that the update procedure fails
or the update image is corrupted, the IPMC will be able to restart all the same by means of its
rollback functionality. The IPMI software package file is stored in the result/ppc405/firmware
path of the release directory tree. To update the IPMI firmware, the CLI command 'download'
is used:
(AT8402 Base Fabric) #download ipmifw tftp://192.168.50.5/ipmi.pkg
Flashing a new IPMI firmware will disable the IPMI Controller for some minutes.
Are you sure to update the IPMI firmware? (y/n)y
...
(AT8402 Base Fabric) #
Software Description
Page 4 - 20
AT8402 User Guide
Advertisement
Table of Contents
