Restoring Your Pre-Installed Software From Cd-Rom; Restoring Your Pre-Installed Software From Cd-Rom - Fujitsu 270Dx User Manual

RESTORING YOUR PRE-INSTALLED
SOFTWARE FROM CD-ROM
If you have access to the internet during
this process visit our Web Site http://www.
8fujitsu.com and check the FAQs for hints.
C A U T I O N
Remember that you must set the Boot
menu in the BIOS setup utility to CD-
ROM Drive, or use the Esc key during
the boot-up sequence to change the
setting so the BIOS loads the operating
system from the CD-ROM, not the hard
drive. (See page 89 for ways to set the
operating system source.)
C A U T I O N
User data and user installed applications
CAN NOT be recovered from the
Recovery CD-ROM.
T r o u b l e s h o o t i n g
Recovery Directions
1. Put the Recovery CD-ROM in the
CD-ROMdrive.
2.Start your notebook.
3. Set the operating system source to be the
CD-ROM drive.
4. Follow the instructions on your screen.
5. When recovery is complete, remove the
Recovery CD-ROM, replace it in its sleeve
and store it.
6. Restart your notebook.
7. Reset your operating system source to be the
hard drive,if you wish.
P O I N T
As long is there is no boot disk in the
CD-ROM drive or the floppy disk drive
your notebook will boot from the hard
drive, regardless of the operating system
source setting.
L i f e B o o k 2 0 0 S e r i e s f r o m F u j i t s u
Your notebook now has all of the software
installed that was installed when you received it
from the factory. You must now set up the file
for your Save-to-Disk function (see Setting Up
Your Save-To-Disk File Allocation starting on
page 93), load any programs which you pur-
chased and installed after you got your note-
book,and restore your data files. If you did not
choose the format and recover option your data
files will still exist. You are now ready to operate.
163