Fujitsu 270Dx User Manual page 137

Figure 4-12 Opening the Memory Upgrade Compartment
Figure 4-13 Removing a Memory Upgrade Module
U s e r I n s t a l l a b l e
To Install a Memory Upgrade Module:
1. Turn off power to your notebook using
the power switch (see Power Off on pages
24-25), and remove any power adapter
(AC or auto/airline).
2. Make sure that all the connector covers
are closed.
3. Turn the notebook bottom side up, with the
front panel toward you.
4. Remove the screws at the front of the
memory upgrade module compartment.
(See Figure 4-12.)
5. Remove the cover by tilting the front edge
up and then pulling forward until the tabs
on the cover are free. (See Figure 4-12.)
6. Remove the memory upgrade module from
the static guarded sleeve.
L i f e B o o k 2 0 0 S e r i e s f r o m F u j i t s u
F e a t u r e s
C A U T I O N
The memory upgrade module can be
severely damaged by electro-static
discharge (ESD). Be sure you are
properly grounded when handling
and installing the module.
7. Align the memory upgrade module with
the part side up. Align the connector edge
of the memory upgrade module with the
connector slot in the compartment. The
connector will be p ointing toward the rear
of the notebook. (Figure 4-13.)
8. Insert the memory upgrade module at a
45° angle. (Figure 4-13.) Press the connec-
tor edge of the module firmly down and
into the connector.
127