Fujitsu 270Dx User Manual page 128

S e c t i o n F o u r
To Install a Module in the
Bay Adapter for Multi-function Bay 2.
1. Align the Bay Adapter for Multi-function Bay
2 with the solid side up and the rounded
edges toward you.
2. Align your Multi-function Bay 1 device with
the finger ridge up and the connector away
from you.
3. Set the Bay Adapter for Multi-function
Bay 2 on top of the Multi-function Bay 1
device and adjust until the finger ridge shows
through the hole in the Bay Adapter for
Multi-function Bay 2,and the alignment pins
on the Multi-function Bay 1 device fit in the
small round holes of the Bay Adapter for
Multi-function Bay 2.
4. Hold the two parts together while installing
in Multi-function Bay 2 according to the
preceding directions.
To remove a module from the Bay Adapter for
Multi-function Bay 2 simply pull them
gently apart.
118
C A U T I O N
The module is not locked into the Bay
Adapter for Multi-function Bay 2. Be
careful to hold on to both parts or you
can easily drop and damage a module or
the adapter.
Figure 4-5 CD-ROM Drive
CD-ROM Drive
Your CD-ROM drive is durable but you must
treat it with care.Please pay attention to the
following points:
The drive rotates the compact disk at very
high speed. Do not carry it around or subject
it to shock or vibration with the power on.
Avoid using or storing the drive or CDs
where they will be exposed to extreme
temperatures.
Avoid using or storing the drive or CDs
where it is damp or dusty.
Avoid using or storing the drive near
magnets or devices that generate strong
magnetic fields.
Avoid storing the drive where it will
be subjected to shock or vibration.
Do not disassemble or dismantle
the CD-ROM drive.
For guidance on loading a CD in your CD-ROM
drive and caring for CD-ROMs see Section Two.
(See pages 36-37.)