Fujitsu 270Dx User Manual page 143

To Remove Your Notebook
from the LANdock
1. From the Start menu, click on Eject PC,
or push the Undock Request Button on
the LANdock.
2. Wait for the Safe to Undock LED to illumi-
nate, even if a message appears on your
screen saying that you may undock.
3. Push the lever on the side of the station
backward until the docking device connec-
tors are completely clear of your notebook.
4. Very carefully lift your notebook clear of
the Alignment pins in the bottom.
P O I N T
If the notebook power switch is turned
off it is always safe to undock. You do
not have to turn on your notebook and
use the Eject PC feature.
U s e r I n s t a l l a b l e
C A U T I O N
The RJ-11 connector on the rear of your
docking device comes with a protective
cover to keep the connector clean. Be
careful to remove it before trying to make
a connection. Save the cover and replace
it when the connector is not in use.
Using Your Notebook
While it is Installed in the LANdock
There are a few differences you will notice
between using your notebook in and out
of the LANdock.
In the LANdock you have added capabilities:
In the Windows 95 Start menu there is a
PC Eject choice between the Suspend mode
and Shutdown selections.(Use the PC Eject
choice or push the "Undock Request Button"
on the LANdock to enable the undocking of
your LifeBook.)
L i f e B o o k 2 0 0 S e r i e s f r o m F u j i t s u
F e a t u r e s
Both an external mouse and an external key-
board can be connected at the same time. Be
sure to plug them into the correct PS/2 ports.
There is an additional PC Card slot.
C A U T I O N
When your notebook is mounted in
the LANdock it is essentially a desktop
PC not a mobile notebook. DO NOT
unplug the docking device with the
operating system active. You may cause
a loss of data and a system error when
you restart your notebook.
133