Fujitsu 270Dx User Manual page 127

C A U T I O N
Be careful aligning and seating modules
in the bay. If the fit is incorrect you may
damage the bay or the module. If the
module does not move easily, remove
it, and check for dirt or foreign objects.
It will require a firm push to latch the
module in place.
module connector
Multi-function Bay 2
Release Latch
grooves
Figure 4-3 Removing and Installing a
Device in Multi-function Bay 2
U s e r I n s t a l l a b l e
To Install or Remove a Device in
Multi-function Bay 2.
1. Close all files and exit all applications.
2. Turn off power to your notebook, close
the display and remove the AC adapter.
(See pages 24-25 for more information.)
3. Turn your notebook upside down with the
bay openings toward you.
To Remove a Device from Multi-function Bay 2
4. Slide the release latch at the left rear corner of
Multi-function Bay 2 toward the outer edge
of your notebook.
5. Slide the device forward until the unit is clear
of the compartment. This will require some
force. Use the finger ridge on the bottom of
the device.
finger ridge
To Install a Device in Multi-function Bay 2
4.Orient the item to be installed with the finger
ridge away from the body of your notebook
L i f e B o o k 2 0 0 S e r i e s f r o m F u j i t s u
F e a t u r e s
and the connector toward the body of
your notebook.
5. With the module connector toward the back
of your notebook align the grooves on the
side of the device with the tracks in the side
of the bay. (Figure 4-3.)
6. Slide the module toward the back of your
notebook until it clicks into place.
Figure 4-4 Installing a Module in the Bay Adapter for
Multi-function Bay 2
117