Fujitsu 270Dx User Manual page 155

S e c t i o n F i v e
Problem
C A U T I O N
Due to ongoing changes in USB
technology and standards, not all USB
devices and/or drivers are guaranteed
to work.
PC Card Problems
A card inserted in the PC Card slot
does not work or is locking up the system.
146
Possible Cause
4. You may have the wrong I/O address
selected for your device.
5. Your device and another device are
assigned the same I/O address.
1. The card is not properly installed
.
2. The card may have been installed with an
application running and your notebook
doesn't know it's there.
3. Your software may not have the correct
software driver active.
4. You may have the wrong I/O address
selected for your PC Card device.
5. Your PC Card device and another device are
assigned the same I/O address.
Possible Solution
4. See your device documentation and
software documentation to determine the
required I/O address.
5. Check all I/O addresses in the BIOS Setup
Utility and your other installed hardware
and software and make sure there are
no duplications.
1. Remove and re-install the card.
(See PC Cards on pages 103-105.)
2. Close your application and
restart your notebook.
3. See your software documentation
and activate the correct driver.
4. See your PC Card documentation to
determine the required I/O address.
5. Check all I/O addresses in the BIOS setup
utility and your other installed hardware
and make sure there are no duplications.