Restoring Your Pre-Installed Software From Cd-Rom - Fujitsu 420D User Manual

Fujitsu 420d: user guide
Hide thumbs Also See for 420D:
Table of Contents

Advertisement

S e c t i o n
F i v e
Figure 5-2 Installing and Removing the
Internal Hard Drive
114
To Remove the Hard Drive:
1. Turn o your notebook using the Power
Switch and remove any Power Adapter.
2. Remove the four screws from the Hard Drive
Chamber in the bottom panel of your note-
book.(Figure 5-2.)
3. Carefully remove the cover.
4.Gently tilt and lift out the hard disk being
very careful not to damage the flexible circuit
connection.
5. Disconnect the connector very carefully or
you will damage the connector pins.
6. Remove the hard drive.
C A U T I O N
Removing or installing the hard drive
with the power on may damage the
drive, the notebook or shock you.
To Install the Hard Drive
1. Carefully plug in the connector to the new
hard drive being sure to align the connector.
(Figure 5-2.) Make sure it seats completely.
2. Tilt and slide the disk drive gently into
the chamber being careful not to kink
the flat cable.
3. Push the disk drive down gently but firmly.
4. Align the cover with the screw holes.
6. Fit the cover tightly in place.
7. Replace the screws.
Restoring Your Pre-installed Software
from CD-ROM
To restore your pre-installed software from the
recovery CD-ROM follow the instructions on
the CD case.
C A U T I O N
Recovery CD-ROMs for your pre-
installed software come with units
that have only Windows 95. There are
no recovery CD-ROMs available for
units that come with a choice of
perating systems.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lifebook 400 series

Table of Contents