Table of Contents
Advertisement
GLOBAL MODE
Configure operation mode to enable/disable DHCP server per system.
Mode
Configure the operation mode per system. Possible modes are:
Enabled: Enable DHCP server per system.
Disabled: Disable DHCP server pre system.
VLAN MODE
Configure operation mode to enable/disable DHCP server per VLAN.
VLAN Range
Indicate the VLAN range in which DHCP server is enabled or disabled. The first VLAN ID must be
smaller than or equal to the second VLAN ID. BUT, if the VLAN range contains only 1 VLAN ID, then
you can just input it into either one of the first and second VLAN ID or both.
On the other hand, if you want to disable existed VLAN range, then you can follow the steps.
1. Press
2. Input the VLAN range that you want to disable.
3. Choose Mode to be Disabled.
4. Press
to apply the change.
Then, you will see the disabled VLAN range is removed from the DHCP Server mode configuration
page.
Mode
Indicate the operation mode per VLAN. Possible modes are:
Enabled: Enable DHCP server per VLAN.
Disabled: Disable DHCP server pre VLAN.
Buttons
: Click to add a new VLAN range
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.
Click to refresh the page. Any changes made locally will be undone.
:
PAGE 53
OPTICAL SYSTEMS DESIGN
to add a new VLAN range.
OSD2524 OPERATOR MANUAL
DOC ID: 10120001
Advertisement
Table of Contents
