Table of Contents
Advertisement
4. Operation
4.7 Save / Recall a program
[Save a program]
1. Set parameters.
2. Keep the [PROG] button pressed over 3 seconds to save your set values.
The LED of [PROG] button and SEC/Save are turned on.
3. Input the program number by using the [▲▼] button.
Up to 10 programs can be stored.
4. Press the [PROG] button again to complete saving.
The set value is saved.
In case of no input for 5 seconds, you will get out of the Save mode.
[Recall a program]
1. To recall a saved program, press the [PROG] button shortly.
The LED of [PROG] and MIN/Call are turned on.
2. Enter the program number you want to recall by pressing [▲▼] button.
3. Press [PROG] button once again.
The set values of the saved program are displayed.
In case of no input for 5 seconds, you will get out of the Recall mode.
4.8 Start / Stop the centrifugation run
1. After setting all parameters, press [START/STOP] button.
While running, the 'START LED' is turned on.
To stop the operation, press the [START/STOP] button while running.
13 l www.ihanil.com
Advertisement
Table of Contents
