Figure 8-3. Unit Access Table - ADTRAN TSU 100 User Manual

Chapter 8. Telnet/Terminal Menus
Units accessed via T-WATCH Pro over TCP/IP use the Unit ID
and passcode set by T-WATCH Pro running on the PC.
____________________Unit Access Table_______________________
Unit ID
20
3
6
8
1) Add New Unit
2) Modify Unit
3) Delete Unit
4) Default Unit Passcode 0022
5) OK
Add New Unit
Add New Unit
device Unit ID, Passcode, Unit Type, and Polled Flag.
•
•
•
•
•
8-6
Passcode Type
DEFAULT Standard
0033 Standard
0095 TSU Standalone
0022 Standard

Figure 8-3. Unit Access Table

adds a new device to the table. You must enter a
Unit type can be Standard (which supports any TSU/TDU
Multiplexer and the ISU 512) or TSU Standalone (a single
port TSU with no option card slot).
A passcode of 0 to 9999 for each device or DEFAULT may
be selected, which results in the default passcode being
used (defined as 0022 in Figure 8-3).
Traps are normally sent from the unit in alarm to the TSU
100.
For units in the Unit Access Table that are not chained di-
rectly to the TSU 100 but are managed over Inband or the
FDL, traps are not automatically forwarded.
Polling must be enabled on the TSU 100 for these units in or-
der to receive Traps on the NMS. The TSU 100 can be con-
figured to poll selected units for traps by enabling the
polled option when adding or modifying a unit entry.
TSU 100 User Manual
Polled PollStatus
No
Yes UP
No
Yes UP
61202052L1-1