Table of Contents
Advertisement
Chapter 2. Installation and Operation
INSTALLING THE UNIT
The OSU 300 can be used as a desktop stand-alone device or
mounted into a standard 19-inch equipment rack. See the section
VT-100 Terminal Connection on page 2-9 for information on terminal
configuration.
Rackmount Installation
Follow these steps to mount your unit into a rack:
1.
Be sure to install the flanges with the screws provided.
2.
3.
4.
2-2
Install the 19-inch rackmount flanges on each side of the OSU
300 enclosure at one of the three available positions.
After the flanges have been installed, position the OSU 300 at
the correct location within the rack and secure the mounting
flanges to the mounting rails of the rack.
Make all network, DTE, and power connections to the rear of
the unit. See the section Powering the Unit on page 2-8 for more
information on making the DC power connection.
Using the 8-position modular to DB-25 female connector and
the 8-position modular to 8-position modular cable, connect a
VT-100 terminal device to the CONTROL interface jack on the
front panel of the unit.
OSU 300 User Manual
61200663L1-1
Advertisement
Table of Contents
