Table of Contents
Advertisement
Chapter 5. Configuration Menu
Menu Item
IP Address
Subnet Mask Defines which part of a destination IP address is the
Default
Router
SLIP Rate
SLIP Flow
CTL
Proxy Traps
5-12
Uniquely identifies the TSU 100 on a TCP/IP
network.
Composed of four decimal numbers, each in the
range of 0 to 255, separated by periods.
Used for either the 10BaseT Ethernet or SLIP
interface, depending on the IP interface setting.
(10BaseT is only available in the TSU 100e)
Network number.
Used along with the TSU 100 IP address to
determine which nodes must be reached through
the default IP Gateway.
Value is ignored when the IP Interface is set to SLIP.
All IP Packets destined for nodes not on the TSU
100 unit's local network are not forwarded through
this IP address. Normally, this address defines a
router connected to the TSU 100 unit's local
network.
Value is ignored when the IP Interface is set to SLIP.
Sets the baud rate for the Chain-In port when used
as the SLIP connection for SNMP management.
Choices: 1200, 2400, 4800, 9600, 19200, 38400
Used to activate flow control on the chain-in port
when used as the SLIP interface. Hardware mode
uses RTS and CTS.
Choices: None, Hardware
Determines whether or not traps will be forwarded
from units being "proxied" for.
Choices: Enable, Disable
TSU 100 User Manual
Description
61202052L1-1
Advertisement
Table of Contents
