Table of Contents
Advertisement
Chapter 3. Operation
T-WATCH Pro EIA-232 Connection
To set up the TSU 100 to work with T-WATCH Pro over a direct
EIA-232 connection, follow these steps:
SNMP
The ADTRAN TSU 100 supports the Simple Network Manage-
ment Protocol (SNMP) through the chain-in (SLIP) interface.
Additionally, the TSU 100e offers a 10BaseT Connection which
also supports SNMP. See Appendix A, Understanding SNMP on
page A-1 for detailed information.
To use SNMP via 10BaseT (TSU 100e only) follow these steps:
3-12
Step
1
Set the Unit ID and set a passcode using the front
panel. See Unit ID Menu on page 6-5 and Change/Set
a Passcode on page 6-4 for details.
2
Set the Chain-in port rate to the same setting as the
PC Com port.
3
Connect the PC Com port to the Chain-in port on
the TSU 100 using the DB25 adapter and modular
cable provided.
4
Follow the installation instructions for T-WATCH
Pro to start the program and to connect to the unit.
Step
1
Set Control Port to Normal.
Set the IP address, default gateway, and subnet
2
mask.
3
Load the appropriate MIB browser into the
Network Management Station.
For more information, see the ADTRAN webpage
at http//www.adtran.com.
4
The MIB browser issues SNMP gets/sets to the
TSU 100e.
TSU 100 User Manual
Action
Action
61202052L1-1
Advertisement
Table of Contents
