Table of Contents
Advertisement
3.3.9 Special Settings & Commands
Special Settings & Commands
In this field extra settings can be entered, used to alter functionality
or to setup alternative modes op operation.
All special setting start with a dot in front, followed by two letters.
Some of them also require a numeric value behind.
There are a few special commands, without the dot.
Special Commands
"SD"
"FORMAT CARD"
"FACTORY"
"FACTORY WIFI"
"FACTORY NOWIFI" = Factory settings AND disable Wi-Fi module & settings.
Special SD card Settings (see also
".SR"
".SA"
".SP"
".FF<max>"
".FS<siz>"
".SI<mhz>"
".CS"
".CR<cou>"
".CW<cou>"
".CD<cou>"
Special Recording Settings
".II"
".IO"
".IL"
".IR"
".IE"
".IN"
".IM"
".IB<sec>"
V-Tap ISDN PRI Manual EN v1.23 Nov 2021
= Show free space on the card after each reboot;
= Format the SD card. All data on the card will be deleted!
= Back to factory settings, except all licenses. IP is default!
= Factory settings AND enable Wi-Fi module & settings.
= Remove files from the card after sending.
= Disable Auto Delete when the card is (almost) full.
= Enable SD Power Save Mode (slow clock during idle).
= Maximum number of Files on the card (default 10000).
= Maximum File Size in MB (default 230).
= SD card Interface Speed in MHz (default 50).
= Show all current SD file-counters;
= Set Read file-counter.
= Set Write file-counter.
= Set Delete file-counter.
= Disable recording of Incoming calls.
= Disable recording of Outgoing calls.
= Record audio of the Local side only.
= Record audio of the Remote side only.
= Record Early; start recording when ringing.
= Disable connected number for the number-list.
= Disable remote number for the number-list.
= Notification Beep interval in seconds, using "NBEEP.WAV".
Special SD card
settings)
© 2018-2021 Vidicode
more
more
info.
info.
25
Advertisement
Table of Contents
Need help?
Do you have a question about the V-Tap ISDN PRI and is the answer not in the manual?
Questions and answers