Vidicode V-Tap ISDN PRI Manual page 41

.CS = Show the card file counters after next login
.CR<cou>
.CW<cou> = Set new Write file counter
.CD<cou>
Enter ".CS" in "Special Settings & Commands" (place at the end, if
there are other settings). The next web login will then show the
current file counters, used by the card filing system.
For example: W=500 R=501 D=1
This shows that the write-counter is on 500, the read-counter on 501
and the delete-counter on 1.
Meaning, that there are 500 files on the card (next file to open is
501), that file 500 was sent successfully to the Tunnel server (next file
to send is 501), and that no file was automatically deleted yet.
When the connection to the Tunnel server is right, then the read-
counter is always one above the write-counter.
The delete-counter only moves, when the SD card is full and old files
are being deleted by the system.
The counters can have a maximum value, the same as the maximum
number of files on the card, and can be changed by the ".FF" setting.
The read-counter can be set back to resend files. For example, ".CR0"
will resend all recorder files from the card to the Tunnel server.
V-Tap ISDN PRI Manual EN v1.23 Nov 2021
= Set new Read file counter
= Set new Delete file counter
© 2018-2021 Vidicode 41