IR Transmission Mode
This feature allows you to select IR transmission mode.
The settings are Full Duplex or Half Duplex. The default setting is Full
Duplex.
Receiver Polarity
This feature allows you to set the reciver polarity if your IR device is used as
a receiver.
The settings are Non Inverted or Inverted. The default setting is Non
Inverted.
Transmitter Polarity
This feature allows you to set the transmitter polarity if your IR device is
used a transmitter.
The settings are: Non Inverted (Default), Inverted.
OnBoard Parallel Port
This option enables the parallel port on the mainboard and specifies the
parallel port base I/O port address.
The settings are: 378 (Default), 278, 3BC, Auto, Disabled.
Parallel Port Mode
This option allows you to select the IRQs of the parallel port.
The settings are Normal, EPP, ECP. The default setting is Normal.
EPP Version
This option allows you to select the EPP version.
The settings are 1.9, 1.7. The default setting is 1.9.
Parallel Port IRQ
This option allows you to select the parallel port IRQ.
The default setting is 5 or 7. The default seting is 7.
Parallel Port DMA Channel
This option allows you to select the parallel port DMA channel.
The settings are 0, 1, or 3. The default setting is 3.
VIA OnBoard PCI IDE
This option allows you to enable the primary and secondary onboard IDE
features. The settings are: Disabled, Primary, Secondary, Both (Default).
AMI BIOS Setup
57