FIC PA-2011 Manual page 52

PA-2011 Mainboard Manual
1st Boot Device
This item allows you to select the first drive for booting up the system.
The settings are Disabled, IDE-1, IDE-2, IDE-3, FLOPPY, FLOPTICAL,
SCSI, or NETWORK. The default setting is FLOPPY.
2nd Boot Device
This item allows you to select the second drive for booting up the system.
The settings are Disabled, IDE-0, or FLOPTICAL. The default setting is
IDE-0.
3rd Boot Device
This item allows you to select the third drive for booting up the system.
The settings are Disabled, FLOPTICAL, CDROM. The default setting is
CDROM.
4th Boot Device
This item allows you to select the fourth drive for booting up the system.
The settings are Disabled or FLOPTICAL. The default setting is Disabled.
Try Other Boot Devices
If you select Yes, the BIOS will try to boot up the system from other boot
devices if all selected boot devices failed to boot. If No selected, the BIOS
will try to boot up the system from only the selected devices.
The settings are Yes or No. The default setting is Yes.
S.M.A.R.T. for Hard Disks
"S.M.A.R.T" stands for "Self-Monitoring, Analysis and Reporting
Technology". To enable it will assist you in preventing some (but not all)
system down time due to hard disk drive failure.
The settings are Disabled or Enabled. The default setting is Disabled.
Quick Boot
Set this option to Enabled to instruct AMI BIOS to boot quickly when the
computer is powered on. This option replaces the old 1MB Memory Test
Advanced Setup option.
The settings are Disabled or Enabled. The default setting is Disabled.
44