FIC PA-2011 Manual page 59

Power Management/APM
Set this option to Enabled to enable the power management and APM
(Advanced Power Management) features.
The settings are Enabled or Disabled. The default setting is Disabled.
Green PC Monitor Power State
This option specifies the power management state that the Green PC-
compliant video monitor enters after the specified period of display inactivity
has expired.
The settings are: Disabled (Default), Suspend, Off, or Stand By.
Video Power Down Mode
This option specifies the power management state that the video subsystem
enters after the specified period of display inactivity has expired.
The settings are: Disabled, Stand By, Suspend (Default).
Hard Disk Power Down Mode
This option specifies the power management state that the hard disk drive
enters after the specified period of display inactivity has expired.
The settings are: Disabled, Stand By, Suspend (Default).
Hard Disk Time Out (Minute)
This option specifies the length of a period of hard disk inactivity. When this
period expires, the hard disk drive enters the power-conserving mode
specified in the Hard Disk Power Down Mode option described above.
The settings are Disabled, 1 minute, and all one minute intervals up to and
including 15 min. The default setting is Disabled.
Stand By Time Out (Minute)
This option specifies the length of the period of system inactivity when the
computer is in Full-On mode before the computer is placed in Stand By
mode. In Stand By mode, some power use is curtailed.
The settings are: Disabled, 1, 2, 5 (Default), 10, 15, 30, 60 mins.
Suspend Time Out (Minute)
This option specifies the length of the period of system inactivity when the
computer is already in Stand By mode before the computer is placed in
Suspend mode. In Suspend mode, nearly all power use is curtailed.
The settings are Disabled, 1, 2, 5 (Default), 10, 15, 30, 60 mins.
AMI BIOS Setup
51