FIC PA-2011 Manual page 60

PA-2011 Mainboard Manual
Standby Clock
This feature allows you to set the system clock in Stand By mode.
The settings are: CPUCLK/2 (Default), CPUCLK/4.
Display Activity, IRQ3, 4, 5, 7, 9, 10, 11, 12, 13, 14, 15
After the time period which you set at in Suspend Mode Feature, the system
advances from Doze Mode to Suspend Mode in which the CPU clock stops
and the screen display is off. At this moment, if the IRQ activity which is
defined as Primary Event (Pri-event) occurs, the system goes back to Full-
on Mode directly.
If the IRQ activity which is defined as Secondary Event (Sec-event) takes
place, the system enters another low power state, Dream Mode, in which the
system will act as Full-on Mode except that the screen display remains off
until the corresponding IRQ handler finishes, then back to Suspend Mode.
For instance, if the system connects to a LAN and receives an interruption
from its file server, the system will enter the dreaming mode to execute the
corresponding calling routine.
The options are: Ignore, Pri-event, Sec-event. The default values of IRQ3, 4,
12, 14, 15 are: Pri-event.
MODEM Use IRQ
This feature allows you to select the IRQ# to meet your modem's IRQ#.
The options are: NA, 3 (Default), 4, 5, 7, 9, 10, 11.
52