Connection - NEC N8100-2089F User Manual

Chapter 2 Preparations
2.2

Connection

Connect peripheral devices to the server.
Connectors that allow a variety of peripheral devices to be connected are provided at the front and rear of the
server. The illustration below shows locations of peripheral devices and their connector available in standard
configuration. First connect the peripheral devices and then connect the power cord to the server. After that,
connect the power plug to the outlet.
154
WARNING
Be sure to observe the following precautions to use the server safety. Failure to
observe the precautions may cause death or serious injury. For details, refer to
Safety precautions in Precautions for Use.
 Do not hold the power plug with wet hands
 Do not connect the ground wire to a gas pipe
CAUTION
Be sure to observe the following precautions to use the server safely. Failure to
observe the precautions may cause burns, injury, and property damage. For
details, refer to Safety precautions in Precautions for Use.
 Use only the specified outlet to insert.
 Do not connect the power cord to an outlet that has an illegal number of
connections.
 Insert the power plug into the outlet as far as it goes.
 Use only the specified power cord
 Do not connect or disconnect the interface cable with the power plugged in
the outlet.
 Use only the specified interface cable
Express5800/T120e User's Guide
2. Installation and Connection