Microcom 438TM Operator's Manual page 91

Chapter 5
cycle or after the restart command. When a stock out occurs the printer will
finish printing the entire label if the LSY is less than the dot-to-gap distance. If
greater, it will continue printing for a distance equal to the dot to gap distance
OR until the label finishes; which ever comes first. The dot-to-gap value is
configurable using the D158 command. The error will be acknowledged at the
end of printing. This will work with all media (continuous, black line, and gap).
5.2.1.8 Software Switch #8
^AB ^D COMMAND
XX 28 Change SW8: Software Switch #8.
^AB12345678 (each bit is represented by a numeric position number)
Position:
1 Reserved
2 Reserved
3 Line Feed: This feature is used to control the line feed. When enabled, the
printer will line feed while the button is pressed and held. When this feature is
disabled, pressing and holding the button will be ignored.
4, 5 Reserved
6 Presenter Option: This command is used to enable the Presenter option.
This command will only function if the printer is compatible with the presenter
option.
7 Reflective Stock Out Detection: When this feature is enabled, the printer
will use reflective sensor to detect stock out conditions. This should only be
used if a Transmissive sensor is not available.
8 LTS Jam Detection: This feature uses the printer's Label Present or Label
Taken sensor to identify a jam condition after sending a print job to the printer.
When enabled, the printer will report the >LPD STOCK JAM< message if the
printer was sent a print job and the LTS did not detect the media exiting the
printer.
438TM Operator's Manual - 880049-0113
1 = Enable Finish Mode
0 = Disable Finish Mode
1 = Disable Line Feed
0 = Enable Line Feed
1 = Enable Presenter
0 = Disable Presenter
1 = Enable Reflective Stock Out Detection
0 = Disable Reflective Stock Out Detection
1 = Enable LTS Jam Detection
0 = Disable LTS Jam Detection
Printer Commands
5-23