Microcom 438TM Operator's Manual page 40

Getting Started
3.6.14.1 Save/Restore - Restore settings from file...
This is used to import or restore driver settings from a .MDS file. The driver settings are
contained within a .MDS file and may be restored or configured if imported using the
Restore feature.
3.6.14.2 Save/Restore - Save settings to file...
This is used to export or save the current settings in a .MDS file. This file contains the driver
setup used to configure the driver.
3.6.14.3 Save/Restore - Restore factory defaults...
This will force the driver defaults of the printer model installed.
3.6.15 Status Messages
This section describes the Windows compatible Status messages that are displayed in
spooler and the Status Monitor feature found on the Modification tab. These messages may
be extracted using the GetPrinterData MSDN API call. The standard message and the
printer meaning are listed below.
3.6.15.1 PRINTER_STATUS_WAITING
This message indicates that the printer is okay and ready to print. LDS1 control language
printer message would be the >READY<.
3.6.15.2 PRINTER_STATUS_BUSY
Message indicates that the printer is busy printing a job. No LDS1 equivalent control
language printer message.
3.6.15.3 PRINTER_STATUS_PAPER_OUT
This message indicates that the printer does not detect media in the printer or has run out of
media. The LDS1 equivalent control language printer message would be >STOCK NOT
LOADED< or >LOW STOCK<.
3.6.15.4 PRINTER_STATUS_PAPER_JAM
Message is used to indicate that the printer has detected a media jam. The LDS1 control
language printer message would be the >LPD STOCK JAM<.
3.6.15.5 PRINTER_STATUS_PAPER_PROBLEM
This message is used to indicate that the optional >INPUT 1< sensor is active. The >INPUT
1< message is the equivalent LDS1 control language printer message that is reported.
3.6.15.6 PRINTER_STATUS_USER_INTERVENTIO N
This message indicates that the printer is in an error condition that needs to be corrected
before the printer may continue. The LDS1 messages that generate this error would be
>CUTTER ERROR<, >DATA ERROR<, >FAIL TIMEOUT<, or >FAIL SIZE< LDS1 control
messages.
3.6.15.7 PRINTER_STATUS_OFFLINE
Message indicates that the printer is powered down or the driver is unable to communicate
with the printer. No LDS1 equivalent control language printer message.
3-28 438TM Operator's Manual - 880049-0113
Chapter 3