Microcom 438TM Operator's Manual page 218

^A ^D COMMAND
XX 85 Load Increment/Decrement Step Value: The ^Axx specifies the value that
the serial number will be incremented or decremented.
X 86 Single Serial Number Status:
0 Disable Increment/Decrement
1 Enable Increment. The serial number will be increased by the ^D85 value.
2 Enable Decrement. The serial number will be decreased by the ^D85 value.
XX 87 Load Field Number to Clear Increment/Decrement Status: Clears the
status of one or more serial numbers.
XX 88 Load Field Number to Increment by 1: The ^Axx specifies which field to
increment when using the multiple serial number function.
XX 89 Load Field Number to Decrement by 1: The ^Axx specifies which field to
decrement when using the multiple serial number function.
XX 90 Reflective Detection Sensitivity: The ^Axx value sets the point (0-255) at
which the printer detects a blackline registration mark using the reflective
sensor. The printer's threshold default is a value of 100 for the reflective
sensor. If this value is not set correctly the printer may false sense a
registration mark or report an invalid >LOW STOCK< error.
XX 91 Transmissive Detection Sensitivity: The ^Axx value sets the point (0-255) at
which the printer detects a diecut registration mark (gap) and/or blow-hole
using the transmissive sensor. The printer's threshold default is a value of 30
for the transmissive sensor. If this value is not set correctly the printer may
false sense a registration mark or report an invalid >LOW STOCK< error.
X 93 Load Control Code Recognition Status:
0 Enable control code recognition
1 Disable control code recognition
XX 95 Load Advance/Retract Distance: Used in conjunction with cutter and
dispense command. The ^Axx specifies the amount to advance after printing
and then retract to dot row. The count is given in dot increments.
XX 96 Retraction Delay: The ^Axx specifies the amount of delay, in
Milliseconds, the printer waits before retracting to dot row in cutter and
dispense modes.
X 97 Tag/Tear Dispense Mode:
0 Disables Tag/Tear Mode
1 Advance after every label.
2 Advance after copies count.
3 Advance when idle.
13-12 438TM Operator's Manual - 880049-0113