Microcom 438TM Operator's Manual page 223

sent along with the ^A1^D143 and ^A2^D143 commands and is typically only
sent when the configuration actually changes.
^A ^D COMMAND
145 List Commands: This command is used to generate a list of commands
containing a brief description of the LDSI code base that the printer uses.
Issuing a ^D145 or ^A0^D145 causes the printer to generate a list of
commands supported by the LDSI code base to communications port.
XX 146 Pre Stock-Out Distance: This command sets the distance in dots that the
PSO option uses to feed the media when the >INPUT 1< sensor detects an
out of media condition. If the length of the label happens to be larger than the
distance from the pre stock out sensor to the dot row (^D146 command) the
printer will not be able to completely finish printing the last label. Other than
this, the operation of the printer will be the same as above. The printer's
default distance is set to 1800 and issuing a "0" (^A0^D146) will cause the
printer to reset to this value. The maximum setting is 7200 and values above
this setting will be ignored.
149 USB Image Print Mode: This is a special Image print mode protocol used
with the USB Port at higher Baud rates.
X 153 Feed Forward Distance: Moves motor in the forward direction by the X
amount specified in dots.
X 154 Feed Reverse Distance: This command will move the motor in the reverse
direction by the X amount, specified in dots.
X 155 Set Feed Speed: Sets the feed speed used with the D153 and D154
commands.
0 8.0 ips (inches per second)
1 7.5 ips
2 7.0 ips
3 6.5 ips
4 6.0 ips
5 5.5 ips
6 5.0 ips
7 4.5 ips
8 4.0 ips
9 3.5 ips
10 3.0 ips
11 2.5 ips
12 2.0 ips
13 1.5 ips
14 1.0 ips
^A ^D COMMAND
438TM Operator's Manual - 880049-0113 13-17