Microcom 438TM Operator's Manual page 17

Chapter 3 Getting Started
The second option is available on code version 1.11.32 and later is a Microcom developed
solution that provide true Ethernet speeds that is not limited to the 115200 serial cap. The
Microcom option board must be installed at the factory and is not intended for field
installation.
3.5.1 Device Installer – Xport
Either type 192.168.200.3 in your Web Browser or run the Device Installer software. Please
note that you will need to add the 192.168.200.3 address to your network in order to
communicate to the printer via the Web Interface.
Please note that the printer's Ethernet port is configured with an IP address of
192.168.200.3, a NET mask of 255.255.255.0, and a local port of 9100.
After starting the Device Installer software, you will see a screen similar to the picture below.
Select the Search button to search for the XPORT device.
438TM Operator's Manual - 880049-0113 3-5